Käyttöohje Hama 00186369 Meteotime Sääasema

Käyttöohje

5

Display Search for DCF signal

Flashing display

Active

Permanent display

Successful -

the signal is being received

Inactive

• The time and date are displayed within a few minutes. However,

receiving the very large amounts of data with the forecast for all

regions and days requires up to 24 hours from the initial start-up

until all data is received.

• After successful reception of the time and date signal, the

display shows FRM (Frankfurt am Main) as the location for the

info window. For information on changing the country and

location, see below.

• If the device has successfully received the Meteotime signal,

the Meteotime symbol

is displayed next to the respective

day of the week.

Display Meteotime status

Valid and updated data

Valid, but not updated data

Inactive

Note - faulty transmission of the measured

values

• In some cases, interference caused by a WiFi network,

computer, TV, etc., for example, may cause the transmission

of measured values between the base station and the outdoor

sensor to fail.

• If this happens, resynchronise the stations by briey removing

the batteries from both stations and reinserting them.

• If the measured values are not transmitted again, replace the

batteries with new ones.

• If necessary, choose a new location for the base station to

avoid the possible interference signals in the future.

Note

You can use the TEST function to search for a better location.

Take the device in your hand to nd a suitable location. Press the

TEST button (D) to check the quality of the Meteotime signal/DCF

signal. The signal strength is displayed as a value from T-1 (very

poor) to T-9 (very good). The TEST takes about one minute. You can

restart or stop the test at any time by pressing the TEST button.

If no signal is received on a repeated basis, press and hold the

DOWN button (F) for around 3 seconds to start the manual search

for the DCF signal. The radio signal (2) starts to ash.

Note - Setting the time

• The search process takes about 5 minutes. If this fails, the search

is terminated and repeated at the top of the next hour. The radio

symbol (2) disappears.

• Meanwhile, you can make a manual setting of the time and date.

• The clock automatically continues to search for the DCF signal

daily. Once the signal is received successfully, the manually set

time and date are overwritten.

Press and hold the DOWN button (F) again for around 3 seconds to

end the manual search process.

Note - Summertime

The time adjusts automatically to summertime. While summertime is

active, DST (1) appears on the display.

6.2 Connection to the outdoor sensor

• After the batteries are inserted, the base station automatically

searches for a connection to the outdoor sensor and carries out

the initial setup routine.

Note

• Initial setup takes around 3 minutes.

• During the connection attempt, the radio signal (2) on the

base station (22) ashes.

• Avoid any operation of the buttons during this time!

Otherwise, errors and inaccuracies may occur in the values

and their transmission.

• The process is nished as soon as the indoor and outdoor

measurement data (23/27/34/36) are displayed.

• If no signal is received from the outdoor sensor on a repeated

basis, press and hold the CHANNEL button (B) for around 3

seconds to start the manual search for the signal.

6.3 Channel selection / Additional outdoor sensors

Note

• You can install two further outdoor sensors in addition to the

outdoor sensor supplied. When doing so, ensure the same

channel setting on the base station and each outdoor sensor.

• Suitable outdoor sensors can be found at www.hama.com

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Hama 00186369 Meteotime Sääasema. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Hama. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Hama 00186369 Meteotime Sääasema käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Hama Sääasemat
Lisää Sääasemat käsikirjoja

Usein kysytyt kysymykset kohteesta Hama 00186369 Meteotime Sääasema

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Hama 00222216 Sylt Sääasema

Käyttöohje

Hama EWS-165 Sääasema

Käyttöohje

Hama 00222238 Palawan Sääasema

Käyttöohje

Hama 00222242 Usedom Sääasema

Käyttöohje

Hama TH-130 Sääasema

Käyttöohje

Hama 00222243 Cres Sääasema

Käyttöohje

Hama EWS-3000 Sääasema

Käyttöohje

Hama 00186301 Sääasema

Aiheeseen liittyvät luokat