Käyttöohje Champion CHSJ310 Silitysrauta

Käyttöohje

EN

ANTI-CALC SYSTEM

A special resin lter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin lter is per-

manent and does not need replacing. Please note: Use tap water only. Distilled and/demineralized water makes the “Zero-Calc”

anti-calc system ineective by altering its physicochemical characteristics. Do not use chemical additives, scented substances or

decalciers. Failure to comply with the above-mentioned regulations leads to the loss of guarantee.

ANTI-DRIP SYSTEM

With the anti-drip system, you can perfectly iron even the most delicate fabrics. Always iron these fabrics at low temperatures.

The plate may cool down to the point where no more steam comes out, but rather drops of boiling water that can leave marks or

stains. In these cases, the Anti-drip system automatically activates to prevent vaporization, so that you can iron the most delicate

fabrics without risk of spoiling or staining them.

AUTOMATIC SHUT OFF

The automatic shut o device trips after the iron has been left for approx. 8 minutes in the upright position or unused for approx.

30 seconds in the horizontal position. The light comes on to indicate that shut o has tripped. As soon as you move the iron, the

device turns o and the iron starts working again.

GENERAL INSTRUCTIONS

When using the iron for the rst time, you may notice a slight emission of smoke and hear some sounds made by the expanding

plastics. This is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth before

using it for the rst time.

PREPARATIONS

Tvätten skall strykas i enlighet med de internationella symbolerna på plaggets etikett, eller om detta saknas , i

enlighet med typen av tyg.

Start ironing the garments requiring a low temperature. This reduces the waiting times (the iron takes less time to heat up than to

cool down) and eliminates the risk of scorching the fabrict.

STEAM IRONING

Filling the reservoir

1. Check that the plug is disconnected from the socket.

2. Move the steam selector (3) to “0” [Fig. 1].

3. Open the lid (2).

4. Raise the tip of the iron to help the water enter the opening without overowing.

5. Slowly pour the water into the reservoir using the special measure (18) and taking care not to go over the maximum level

indicated by “MAX” on the reservoir [Fig. 2].

6. Close the lid (2).

Selecting the temperature

1. Put the iron in a vertical position.

2. Put the plug in the socket.

3. Adjust the thermostat knob (14) according to the international symbol on the garment label [Fig. 3]. The plate temperature

pilot light (12) indicates that the iron is heating up. Wait until the plate temperature pilot light goes o before ironing.

Warning: during ironing, the plate temperature pilot light (12) comes on at intervals, indicating that the selected temperature is

maintained. If you lower the thermostat temperature after ironing at a high temperature, do not start ironing until the plate

temperature control light comes on again.

Selecting the steam

1. The quantity of steam is regulated by the steam selector (3).

2. Move the steam selector to a position between minimum and maximum depending on the quantity of steam required and

the temperature selected [Fig. 1].

Warning: The iron gives o steam continuously only if you hold the iron horizontally. You can stop the continuous steam by placing

the iron in a vertical position or by moving the steam selector to “0”. As indicated on the thermostat knob (14) and in the initial

table, you can only use steam at the highest temperatures. If the selected temperature is too low, water may drip onto the plate.

LABEL FABRIC TYPE THERMOSTAT

.

Synthetic

. Low temperature

..

Silk - wool

.. Medium temperature

...

Cotton - linen

... High temperature

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Champion CHSJ310 Silitysrauta. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Champion. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Champion CHSJ310 Silitysrauta käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Champion Silitysraudat
Lisää Silitysraudat käsikirjoja

Usein kysytyt kysymykset kohteesta Champion CHSJ310 Silitysrauta

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Champion CHSJ215 Silitysrauta

Käyttöohje

Philips PSG6066 PerfectCare Silitysrauta

Käyttöohje

Tefal FV2883T0 Silitysrauta

Käyttöohje

Philips GC2220 Silitysrauta

Käyttöohje

Point POGC7000 Silitysrauta

Käyttöohje

Melissa 16390052 Silitysrauta

Käyttöohje

Philips PSG6042 PerfectCare Silitysrauta

Käyttöohje

Point POGC5010S Silitysrauta

Aiheeseen liittyvät luokat