Käyttöohje Black and Decker GTC5455PCB Pensasleikkuri

Käyttöohje

7

ENGLISH

(Original instructions)

u Charge only using the charger provided with the tool.

u When disposing of batteries, follow the instructions given

in the section "Protecting the environment".

Do not attempt to charge damaged batteries.

Chargers

u Use your BLACK+DECKER charger only to charge the

battery in the tool with which it was supplied. Other batter-

ies could burst, causing personal injury and damage.

u Never attempt to charge non-rechargeable batteries.

u Have defective cords replaced immediately.

u Do not expose the charger to water.

u Do not open the charger.

u Do not probe the charger.

$

The charger is intended for indoor use only.

+

Read the instruction manual before use.

Important: Only the following chargers should be used to

charge the 54v battery BL1554 & BL2554:

90589867, 90621477, 90590287-01, 90590289-01, 90602042-

01, 90590287-02, 90590289-02, 90599854-02, 90599854-06,

90599853-05, 90634971, 90634972, 90634973, 90642266,

90642264, 90642265, BDC2A

Electrical safety

#

Your charger is double insulated; therefore no

earth wire is required. Always check that the

mains voltage corresponds to the voltage on the

rating plate. Never attempt to replace the charger

unit with a regular mains plug.

u If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised BLACK+DECKER Service

Centre in order to avoid a hazard.

Features

This tool includes some or all of the following features.

1. Trigger switch

2. Lock off switch

3. Handle

4. POWERCOMMAND button

5. Blade guard

6. Bail handle

7. Blade

8. Saw blade

9. Saw blade shoe

10. Dualvolt battery pack (Only with GTC5455PC unit)

11. Dualvolt panel (Only with GTC5455PC unit)

12. Charger (Only with GTC5455PC unit)

Assembly

Warning! Before assembly, remove the battery from the tool

t the blade sheath over the blades.

Warning! Before assembly, make sure that the tool is

switched off and unplugged and that the blade sheath is tted

over the blades.

Warning! Never use the tool without the guard.

Charging procedure

BLACK+DECKER chargers are designed to charge

BLACK+DECKER battery packs.

u Plug the charger (12) into an appropriate outlet before

inserting the battery pack.

u Insert the battery pack into the charger as shown in gure

A.

u The green LED (12a) will ash indicating that the battery is

being charged.

u The completion of charge is indicated by the green LED

(12a) remaining on continuously. The pack is fully charged

and may be used at this time or left on the charger.

Note: Recharge discharged batteries as soon as possible

after use or battery life may be greatly diminished. For longest

battery life, do not discharge batteries fully. It is recommended

that the batteries be recharged after each use.

Leaving the battery in the charger

The charger (12) and battery pack (11) can be left connected

with the LED glowing indenitely. The charger will keep the

battery pack fresh and fully charged.

Important charging notes

u Longest life and best performance can be obtained if

the battery pack is charged when the air temperature is

between 65°F and 75°F (18°- 24°C). DO NOT charge the

battery pack in an air temperature below +40°F (+4.5°C),

or above +105°F (+40.5°C). This is important and will

prevent serious damage to the battery pack.

u The charger and battery pack may become warm to touch

while charging. This is a normal condition, and does not

indicate a problem. To facilitate the cooling of the battery

pack after use, avoid placing the charger or battery pack

in a warm environment such as in a metal shed, or an

uninsulated trailer.

u If the battery pack does not charge properly:

u Check current at receptacle by plugging in a lamp or

other appliance.

u Check to see if receptacle is connected to a light switch

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Black and Decker GTC5455PCB Pensasleikkuri. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Black and Decker. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Black and Decker GTC5455PCB Pensasleikkuri käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Black and Decker Pensasleikkurit
Lisää Pensasleikkurit käsikirjoja

Usein kysytyt kysymykset kohteesta Black and Decker GTC5455PCB Pensasleikkuri

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Black and Decker GT534 Pensasleikkuri

Käyttöohje

Black and Decker GTC3655L Pensasleikkuri

Käyttöohje

Black and Decker GTC1850L Pensasleikkuri

Käyttöohje

Black and Decker GTC36552PC Pensasleikkuri

Käyttöohje

Black and Decker GTC18452PC Pensasleikkuri

Käyttöohje

Black and Decker GT430 Pensasleikkuri

Käyttöohje

Black and Decker MT18SSK Pensasleikkuri

Käyttöohje

Black and Decker GTC2451 Pensasleikkuri

Aiheeseen liittyvät luokat