Käyttöohje Philips GC6004 Silitysrauta

Käyttöohje

not be visible when you wear or use the article.

Start ironing at a relatively low temperature and

gradually increase it until the desired result is

achieved.

• When steam-ironing woollen fabrics,shiny patches

may occur.You can prevent this by using a dry

pressing cloth or by turning the article inside out

and ironing the reverse side.

• Velvet and other fabrics that tend to acquire shiny

patches should be ironed in one direction only

(along with the nap) while applying very little

pressure.

Make sure you keep the appliance moving

continuously while ironing.

• It is not advisable to use steam when you are

ironing coloured silk:this could cause stains.

Steam-ironing

Filling the tank before ironing

- Make sure that the on/off switch (D) has been set

to ‘off’,that the appliance has cooled down and

remove the plug from the wall socket.

- Slowly unscrew cap (A) of the steam tank (fig.2).

• It is possible that there is a vacuum in the cold tank,

which may cause a sound when you remove the cap.

This is absolutely normal.

- Pour max.1 litre of water into the water tank.

Note:Make sure the tank is full when you start

ironing.

• You can use tap water if it is not too hard (less than

10° DH).If the water in your area is very hard,you

may use distilled water,which you can obtain from

your local supermarket or chemist.

• Do not put perfume,vinegar,starch or

descaling agents in the water tank.Do not

use water from a water softener either.

- If some water remains behind in the filling opening,

gently move the tank to and fro until the water is

gone.

- Firmly fasten the cap.

Heating up

- Put the plug in the wall socket and let the appliance

heat up by setting the on/off switch (D) to ‘on’

(fig.3).

• The steam tank as well as the soleplate are now

being heated up.Heating of the soleplate takes

approx.2 minutes;heating of the steam tank takes

approx.8 minutes.

• Types GC6005/6004 only:as soon as the steam tank

is hot enough for steaming,pilot light (E) will go out.

You may now start ironing.

Steam-ironing

• Steam-ironing is only possible at high ironing

temperatures.

- Keep the steam activator button (H) pressed in

while you are steam-ironing (fig.4).

• Types GC6005/6004 only:during steam-ironing,pilot

lights (E) and (G) will come on from time to time to

indicate that the steam tank and the iron are being

heated up to the right temperature and pressure

respectively.When this happens,you can simply

continue ironing.

• When you have not used the steaming facility for

some time,the steam still present in the supply hose

will condense into water.The next time you steam-

iron,this may cause some spluttering in the

appliance and a few droplets of water may escape

from the soleplate.

Tip: to prevent this,hold the iron over an old cloth and

press the steam activator button (I) until the steam

production has normalised before you start steam-

ironing.

Steaming in vertical position

Hanging curtains and clothes (jackets,suits,coats) can

be steam-ironed by holding the iron in vertical position

(fig.5).

Steam control (Types GC6005/6004 only)

• For moderate steam:set the steam control (F) to

q (the small cloud).

• For a lot of steam:set the steam control (F) to

q (the large cloud) and set the temperature

control (I) to position

33

or MAX.

Fast refill

Follow the instructions below:

- First set the on/off switch (D) to ‘off’.

- Press the steam activator button until you no longer

hear any steam escaping from the appliance.

- Keep the steam activator pressed in and slowly

unscrew the cap of the steam tank by turning it anti-

clockwise.The steam tank is now depressurised

- Remove the plug from the wall socket.

- Fill the water tank as described in section ‘filling the

tank before ironing’ and let the appliance heat up

again.

6

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Philips GC6004 Silitysrauta. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Philips. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Philips GC6004 Silitysrauta käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Philips Silitysraudat
Lisää Silitysraudat käsikirjoja

Usein kysytyt kysymykset kohteesta Philips GC6004 Silitysrauta

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Philips DST7511 Azur Silitysrauta

Käyttöohje

Philips GC2220 Silitysrauta

Käyttöohje

Philips GC8752 Silitysrauta

Käyttöohje

Philips GC9231 Silitysrauta

Käyttöohje

Philips DST3020 Silitysrauta

Käyttöohje

Philips DST7040 Silitysrauta

Käyttöohje

Philips GC7320 Silitysrauta

Käyttöohje

Philips HI5920 Silitysrauta

Aiheeseen liittyvät luokat