Käyttöohje Hoover TCP2010 011 Capture Pölynimuri

Käyttöohje

CLEANER MAINTENANCE

ACCESSORIES AND NOZZLES

Replacing The Dust Bag

If the bag check indicator is red please check and, if necessary, replace the bag.

Lift the bag door release latch 1. [13] to open the cover, pull the bag holder [14] and pull the

bag collar to remove the bag [15].

Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust bag 2.

should be disposed of correctly and carefully.

Fold a new bag as shown on the bag and t by inserting the collar into the bag holder.3.

Ret the bag holder and close the bag door.4.

Warning - The bag door will NOT close if the dust bag and/or the bag holder are not assembled

to the cleaner. Always ensure the bag and bag holder are present when closing the bag door.

Remember: The bag check indicator may also be red if an obstruction has occurred. In this case

refer to ‘Removing A Blockage From the System’.

Cleaning the Filters

To maintain optimum performance of your cleaner, please wash the lters after each 5 bag

changes.

Cleaning the pre-motor lter:

Lift the bag door release latch 1. [13] to open the cover and remove the bag holder.

To remove the pre-motor lter slide the pre-motor lter frame from the cleaner. 2. [16]

Remove the lter from the holder.3. [17]

Wash it in hand warm water, 4. [20] and allow it to dry thoroughly before replacing to the

cleaner [21].

Cleaning the exhaust lter:

To remove the exhaust lter, unclip the exhaust lter cover 1. [18] and remove the lter pack.

[19]

Wash the lter in hand warm water 2. [20] and allow it to dry thoroughly before replacing to

the cleaner. [21].

Remember: Do not use hot water or detergents. In the unlikely event of the lters becoming

damaged, t a Genuine Hoover replacement. Do not try and use the product without a dust

bag or lter tted.

Cleaning the permanent cloth dust bag*

To maintain optimum performance we recommend that you wash the permanent cloth dust

bag under hand warm water after every 5 full bags. Remove excess water and leave to dry fully

before replacing.

2

*Certain models only

GB

Removing a Blockage From The System

If the bag check indicator is illuminated or ashing:

Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.1.

If it is not full, then;2.

Do the lters need cleaning? If so refer to ‘Cleaning the Filter’.A.

Check if there is any other blockage in the system - Use a rod or a pole to remove any B.

blockage from the Teletube or exible hose.

Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a

blockage or if the lters are dirty. If the cleaner is used for a signicant period of time with the

bag check indicator is red, a thermal cut out will switch the cleaner o to prevent overheating.

The bag check indicator turn green once the cleaner has switched o to signal that the thermal

cut out has been activated. If this should happen, switch the cleaner o, unplug and correct the

fault. It will take about 30 minutes for the cut out to automatically reset.

All accessories can be tted to the end of the handle or the end of the tube. [23]

2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice tool.

By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored neatly at

the rear of the cleaner. [22]

Crevice Tool – For corners and hard to reach areas.

Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend the

brushes push the button on the body of the tool.

Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep

cleaning on textile surfaces and other hard to clean areas [1T].

Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep

cleaning on textile surfaces and other hard to clean areas. [1U]

Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1V]

Hard Floor Caresse Nozzle*– For wooden oors and other delicate oors. [1W]

IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long

fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary

while the brush is rotating.

CaptureManual__1-3_union.indd 2 18/04/2011 12.34.13

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Hoover TCP2010 011 Capture Pölynimuri. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Hoover. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Hoover TCP2010 011 Capture Pölynimuri käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Hoover Pölynimurit
Lisää Pölynimurit käsikirjoja

Usein kysytyt kysymykset kohteesta Hoover TCP2010 011 Capture Pölynimuri

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Hoover SN70_SN04011 Pölynimuri

Käyttöohje

Hoover TCR4238 011 Rush Pölynimuri

Käyttöohje

Hoover TCP1805 011 Capture Pölynimuri

Käyttöohje

Hoover TR T5756 021 Telios Pölynimuri

Käyttöohje

Hoover RU80_RU50011 Pölynimuri

Käyttöohje

Hoover TX40PET 011 Pölynimuri

Käyttöohje

Hoover SN70_SN12011 Pölynimuri

Käyttöohje

Hoover TRTW1650011 Sprint Pölynimuri

Aiheeseen liittyvät luokat