EN
2 Ferm
TROLLEY JACK
Carfully read the instructions before you
use the trolley jack!
Contents
1. Machine data
2. Safety instructions
3. Operation
4. Maintenance
1. Machine data
Technical specification
Carrying capacity 2000 kg
Lifting height (min/max) 135/356 mm
2. Safety instructions
The following symbols are used in these
instructions for use:
Denotes risk of personal injury, loss of life
or damage to the machine in case of non-
observance of the instructions in this
manual.
Make sure the oil level is correct
Special safety rules
Non-observance of the following
instructions can cause personal injuries
and/or damage to the vehicle.
• Placethesaddleofthejackonlyinthespot
designed for this purpose. For the relevant
jackingpointspleaserefertoyourcar
instructions.
• Themaximumloadindicatedonthejackmust
never be exceeded.
• Thejackmustbeusedasaliftingdeviceonly.
• Alwaysplacethejackonahardandlevel
surface.
• Alwaysprotectthecarfromrollingaway.
Beforejackingupthecar,placechocksbehind
and in front of the wheels remaining on the
ground,ifnecessary.Putthecarinfirstgearor
put on the handbrake to further block the car.
• Makesuretoplacethejackinsuchawaythat
your hand is not underneath the car when
jackingitup.
• Makesurethejackishorizontal.
• Foryourownsafety,beforeworkingor
crawlingunderneaththecarjackupthecar
and support the shafts.
• Beforeusingtheshaftsupportsmakesure
they are in good condition.
3. Operation
Lifting
Turn the screw of the relief valve clockwise as far
aspossible.Thetrolleyjackisnowreadytolift.
Putthetrolleyjackhorizontallyonaflatsurface,
put the lever in the proper hole and start pumping
by moving the lever up and down.
Shaft supports
Afterjackingupthecartheshaftsupportsshould
be installed. Lower the car by turning the the
screwofthereleasevalveanticlockwise,untilthe
car rests on the supports. Never work under a car
whichonlyrestsonthetrolleyjack.
Lowering
Aftertheworkisfinished,thecarisliftedagain
until the shaft supports are clear. Remove the
shaft supports. Turn the screw of the relief valve
anticlockwise and the car will be lowered. The
further the screw is turned anticlockwise the faster
the car will be lowered.
4. Maintenance
Regular maintenance of your trolley jack
prevents problems!
• Onceamonththewheels,shaftsandpiston
rods should be lubricated with lubricating oil
and grease on the pivots of the lifting rods.
• Thetankcontaininghydraulicoilisaclosed
tank which usually does not require
maintenance.Whenfrequentlyused,butat
leastonceayear,theoilshouldbechanged.
For this purpose the top of the tank is fitted
with an oil drain plug.
Only hydraulic oil should be used for
refilling. Do not use engine or brake fluid.
Keskustele tuotteesta
Täällä voit jakaa mielipiteesi FERM TJM1008 Tunkki:sta. Jos sinulla on kysyttävää, lue ensin huolellisesti käyttöohje. Käsikirjaa voi pyytää yhteydenottolomakkeellamme.
vastaa | Tästä oli apual (0) (Googlen kääntämä)