Käyttöohje Einhell GE-SC 36/35 Li Sammalenpoistaja-sähköharava

Käyttöohje

GB

- 25 -

All 3 LEDs are lit:

The battery is fully charged.

2 or 1 LED(s) are lit:

The battery has an adequate remaining charge.

1 LED fl ashes:

The battery is empty, recharge the battery.

All LEDs blink:

The battery temperature is too low. Remove the

battery from the equipment, keep it at room tem-

perature for one day. If the fault reoccurs, this me-

ans that the rechargeable battery has undergone

exhaustive discharge and is defective. Remove

the battery from the equipment. Never use or

charge a defective battery.

6. Operation

Caution!

The scarifi er is equipped with a safety switch to

prevent unauthorized use. Directly before starting

up the scarifi er insert the safety plug (Fig. 21/Item

14) and remove the safety plug again when inter-

rupting or terminating your work.

To prevent accidental start-up of the scarifi er, the

push bar (Fig. 22/Item 3) is equipped with a safety

lock-off (Fig. 22/Item 1) which must be pressed

before the lever switch (Fig. 22/Item 2) can be

pressed. The start time for the equipment can

amount to several seconds. If the lever switch is

released, the scarifi er switches off . Repeat this

process several times so that you are sure that

your equipment functions properly. Always pull

out the safety plug before performing any adjus-

ting, repair, maintenance or cleaning work on the

equipment. Make sure that the spike drum is not

rotating.

Danger! Never open the ejector fl ap when the

motor is running. A rotating cutting unit can cause

injuries.

Always fasten the ejector fl ap carefully. The fl ap

fl ips back to the “Closed” position by the tension

springs!

Always ensure that a safe distance (provided

by the long handles) is maintained between the

user and the housing. Be especially careful when

scarifying and changing direction on slopes and

inclines. Maintain a solid footing and wear sturdy,

non-slip footwear and long trousers. Always sca-

rify along the incline (not up and down).

For safety reasons, the scarifi er may not be used

to scarify inclines whose gradient exceeds 15

degrees.

Use special caution when backing up and pulling

the scarifi er (tripping hazard)!

Tips for proper working

It is recommended that you overlap scarifying

paths a little.

Try to scarify in straight lines for a nice, clean look.

Insodoing, the aeration swaths should always

overlap each other by a few centimeters in order

to avoid bare strips.

If you use the catch bag which is available as an

option, it has to be emptied as soon as grass clip-

pings start to trail behind during scarifying.

Danger! Before taking off the grass basket,

switch off the motor and wait until the roller

has come to a stop.

To remove the grass basket, lift up the ejector fl ap

with one hand, while unhooking the basket with

the other.

How frequently you should scarify your lawn is

determined primarily by the speed at which the

grass grows and the hardness of the soil.

Keep the underside of the equipment clean and

remove soil and grass build-up. Deposits make it

more diffi cult to start the aerator and decrease the

quality of the scarifying.

Always scarify along inclines (not up and down).

Switch off the motor before doing any checks on

the roller.

Danger!

The roller rotates for a few seconds after the

motor is switched off . Never attempt to stop the

roller. In the event that the rotating roller strikes

an object, immediately switch off the equipment

and wait for the roller to come to a complete stop.

Then inspect the condition of the roller. Replace

any parts that are damaged (see section 7.3).

Tips on aerating properly with the aerator

roller available as an option.

The way of working for aerating is the same as for

scarifying.

You should therefore observe these safety inst-

ructions and notes on working practice.

Anl_GE_SC_36_35_Li_SPK13.indb 25 08.03.2022 13:41:14

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Einhell GE-SC 36/35 Li Sammalenpoistaja-sähköharava. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Einhell. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Einhell GE-SC 36/35 Li Sammalenpoistaja-sähköharava käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Einhell Sammalenpoistaja-sähköharavat
Lisää Sammalenpoistaja-sähköharavat käsikirjoja

Usein kysytyt kysymykset kohteesta Einhell GE-SC 36/35 Li Sammalenpoistaja-sähköharava

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Einhell GC-SA 1231/1 Sammalenpoistaja-sähköharava

Käyttöohje

Einhell GE-SA 36/35 Li Sammalenpoistaja-sähköharava

Käyttöohje

Einhell GE-SA 1435/1 Sammalenpoistaja-sähköharava

Käyttöohje

Einhell GC-SC 18/28 Li Sammalenpoistaja-sähköharava

Käyttöohje

Scheppach SC36 Sammalenpoistaja-sähköharava

Käyttöohje

Husqvarna S 138C Sammalenpoistaja-sähköharava

Käyttöohje

Scheppach SC50Vario Sammalenpoistaja-sähköharava

Käyttöohje

AL-KO Combi-Care 38 P comfort Sammalenpoistaja-sähköharava

Aiheeseen liittyvät luokat