56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E-T10
BH1001 when using the EGO Battery pack 6.0 Ah or
higher capacity.
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a “click” (Fig. G1).
To Detach
Depress the battery-release button and pull the battery
pack out (Fig. G2).
HOLDING THE LINE TRIMMER (FIG. H)
For safe and better operation, put on the shoulder strap
across the shoulder. Adjust the shoulder strap length and
placement to a comfortable operating position – hold the
trimmer with both hands: one hand on the rear handle
and the other hand on the front handle.
NOTICE: The trimmer head is parallel to the ground at
a proper cutting distance without the operator bending
over.
WARNING: When an emergency occurs, take the
shoulder strap off from your shoulder immediately, no
matter what way the strap is on.
STARTING/STOPPING THE LINE TRIMMER (FIG. J)
To Start
Move the lock-off switch forward and then press the
variable speed trigger.
J-1 Lock-off switch J-2 Variable speed trigger
The trigger is stepless speed adjusting. The more you pull
up the trigger, the higher speed it is. Adjust the speed to
suit the task at hand.
NOTE: The motor starts only when the lock-off switch
is moved forward and the variable speed trigger is
depressed at the same time.
To Stop
Move the line trimmer away from the cutting area and
release the variable speed trigger.
WARNING: Always remove the battery pack from the
line trimmer during work breaks and after finishing work.
SPEED ADJUSTMENT FUNCTION (FIG. K)
The line trimmer has two speed settings. Move the high/
low speed switch forward or backward to choose the low
or high speed.
K-1 High/Low-speed switch
USING THE LINE TRIMMER
Clear the area to be cut before each use. Remove all
objects, such as rocks, broken glass, nails, wire, or lien
that can be thrown or become entangled in the cutting
attachment. Clear the area of children, bystanders,
and pets. At a minimum, keep all children, bystanders
and pets at least 15 m away; there still may be risk to
bystanders from thrown objects. Bystanders should be
encouraged to wear eye protection. If you are approached,
stop the motor and cutting attachment immediately.
Before each use check for damaged/worn parts
Check the trimmer head, guard, shoulder strap, shoulder
strap loop, and front handle. Replace any parts that are
cracked, warped, bent, or damaged in any way.
The line-cutting blade on the edge of the guard can dull
over time. It is recommended that you periodically sharp-
en it with a file or replace it with a new blade.
WARNING: Always wear gloves when mounting
or replacing the guard or when sharpening or
replacing the line-cutting blade. Note the location of
the blade on the guard and protect your hands from
injury.
Check for blockage of the trimmer head
◾ To prevent blockage, keep the trimmer head clean.
Remove grass clippings, leaves, dirt and any other
accumulated debris before and after each use.
◾ When blockage happens, stop the line trimmer and
remove the battery, then remove any grass that may
have wrapped itself around the motor shaft or trimmer
head.
After each use, clean the trimmer.
ADJUSTING THE CUTTING LINE LENGTH (FIG. L)
The trimmer head allows the operator to release more
cutting line without stopping the motor. As line becomes
frayed or worn, additional line can be released by lightly
tapping the trimmer head on the ground while operating
the trimmer.
WARNING: Do not remove or alter the line cutting
blade assembly. Excessive line length will cause the
motor to overheat and may result in serious personal
injury.
For best results, tap the trimmer head on bare
ground or hard soil. If line release is attempted in
tall grass, the motor may overheat. Always keep the
trimming line fully extended. Line release becomes
Keskustele tuotteesta
Täällä voit jakaa mielipiteesi EGO ST1511E-T Nurmikon reunaleikkuri:sta. Jos sinulla on kysyttävää, lue ensin huolellisesti käyttöohje. Käsikirjaa voi pyytää yhteydenottolomakkeellamme.