Käyttöohje Black and Decker VPX1101 Ruuvitaltta

Käyttöohje

5

ENGLISH

When assessing vibration exposure to determine safety

measures required by 2002/44/EC to protect persons

regularly using power tools in employment, an estimation of

vibration exposure should consider, the actual conditions of

use and the way the tool is used, including taking account of

all parts of the operating cycle such as the times when the

tool is switched off and when it is running idle in addition to

the trigger time.

Labels on tools

Additional safety instructions for batteries and chargers

Batteries

X Never attempt to open for any reason.

X Do not expose the battery to water.

X Do not expose the battery to heat.

X Do not store in locations where the temperature may

exceed 40 °C.

X Charge only at ambient temperatures between 10 °C

and 40 °C.

X Charge only using the charger provided with the tool.

X When disposing of batteries, follow the instructions

given in the section "Protecting the environment".

Chargers

X Use your Black & Decker charger only to charge the

battery with which it was supplied. Other batteries could

burst, causing personal injury and damage.

X Never attempt to charge non-rechargeable batteries.

X Have defective cords replaced immediately.

X Do not expose the charger to water.

X Do not open the charger.

X Do not probe the charger.

Electrical safety

This charger is double insulated; therefore no earth

wire is required. Always check that the power

supply corresponds to the voltage on the rating

plate.

X If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Features

1. Quick release collar

2. Speed selector switch

3. Forward/reverse and lock-off button

4. Battery compartment

5. Battery release button (on battery)

6. On/off trigger switch

Assembly

Installing the battery pack (fig. A)

Warning! Make sure that the lock-off button (3) is engaged

to prevent accidental switch actuation before removing or

installing a battery.

X Insert the metal terminal end of the battery pack into the

battery compartment (4) until you hear the lock click into

place and the VPX™ logo shows through the window.

Warning! The battery will only fit one way, do not force it. If

the battery does not fit, remove it and put it in the other way.

Removing the battery pack (fig A)

X Press the battery pack release button (5) and firmly pull

the battery pack out of the battery compartment (4).

Charging the batteries (fig. B)

Warning! Do not charge battery packs at ambient

temperatures below 10 °C or above 40 °C.

Note: The charger will not charge a battery pack if the cell

temperature is below approximately 0 °C or above 60 °C.

The battery pack should be left in the charger and the

charger will begin to charge automatically when the cell

temperature warms up or cools down.

X Plug in the charger (8) and switch on at the mains.

X Insert the battery pack (7) into the charger. Make sure

that the battery pack is fully seated in the charger (8).

X The charging indicator (9) will flash continuously

(slowly).

X Leave the battery to charge for at least 5 to 6 hours.

X The charge is complete when the charging indicator (9)

lights continuously

X The charger and the battery pack can be left connected

indefinitely with the LED illuminated. The LED will

change to flashing (charging) state, as the charger

occasionally “tops off “ the battery charge.

Warning! To reduce the risk of injury, the user

must read the instruction manual.

The charger is intended for indoor use only.

Read the instruction manual before use.

The charger automatically shuts off if the

ambient temperature becomes too high. As

soon as the ambient temperature has cooled

down, the charger will resume operating.

Charge only at ambient temperatures between

10 °C and 40 °C.

Charging.

+40ºC

+10ºC

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Black and Decker VPX1101 Ruuvitaltta. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Black and Decker. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Black and Decker VPX1101 Ruuvitaltta käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Black and Decker Ruuvitaltat
Lisää Ruuvitaltat käsikirjoja

Usein kysytyt kysymykset kohteesta Black and Decker VPX1101 Ruuvitaltta

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Black and Decker KC9006 Ruuvitaltta

Käyttöohje

Black and Decker PP360 Ruuvitaltta

Käyttöohje

Black and Decker AS36LN Ruuvitaltta

Käyttöohje

Black and Decker KC9024 Ruuvitaltta

Käyttöohje

Black and Decker BCF602 Ruuvitaltta

Käyttöohje

Black and Decker KC460LN Ruuvitaltta

Käyttöohje

Black and Decker KC1036 Ruuvitaltta

Käyttöohje

Black and Decker HP9096 Ruuvitaltta

Aiheeseen liittyvät luokat