Käyttöohje Black and Decker BDPE400 Saumauspistooli

Tarvitsetko käyttöoppaan Black and Decker BDPE400 Saumauspistooli? Alta voit katsoa ja ladata suomenkielisen PDF-oppaan ilmaiseksi. Tällä tuotteella on tällä hetkellä 1 usein kysytty kysymys, 2 kommenttia ja 0 ääntä. Jos tämä ei ole haluamasi käyttöopas, ota meihin yhteyttä.

Onko tuotteessa vika, eikä käyttöoppaasta ole apua? Siirry Repair Café ‑alueelle etsimään ilmaisia korjauspalveluita.

Käyttöohje

Loading…

4
ENGLISH
(Original instructions)
Additional safety instructions for non-rechargeable
batteries
@
Warning! Batteries can explode or leak, and can
cause injury or re. Observe the instructions as
described below.
u Ensure the switch is in the off position before inserting bat-
teries. Inserting batteries into power tools and appliances
that have the switch on invites accidents.
u Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally occurs,
ush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause
irritation or burns.
u Carefully follow all instructions and warnings on the bat-
tery label and package.
u Always place batteries correctly according to the polarity
(+ and -) as marked on the battery and the product.
u Do not short-circuit the battery terminals.
u When battery/battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can make a con-
nection from one terminal to another. Shorting the battery
terminals together may cause burns or a re.
u Do not attempt to charge non-rechargeable batteries.
u Do not mix old and new batteries. Replace all of them at
the same time with new batteries of the same brand and
type.
u Keep batteries out of reach of children.
u Remove batteries if the product will not be used for
several months.
u Never attempt to open for any reason.
u Do not store in locations where the temperature may
exceed 40 °C.
u When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
u Do not incinerate the batteries.
u Do not expose the batteries to heat
Features
This appliance includes some or all of the following features.
1. Paint applicator
2. Speedy Edge main body
3. Paint reservoir syringe
4. Plunger drive
5. Trigger
6. Flow control knob
7. Battery cap
8. Fill sleeve
Assembly
Fitting the batteries (g. A)
u Remove the battery cap (7) by pressing in the tabs (9) and
then sliding the battery cap (7) off the handle.
u Insert 3 AA (LR06 - Alkaline) batteries into the handle.
u Ret the battery cap (7) by sliding it back on to the handle.
Note: Always place batteries correctly according to the polar-
ity (+ and -) as marked on the battery and the product.
Fitting the paint applicator (g. B)
u Press in the paint applicator release tabs (10).
u Slide the paint applicator into the front of the main body
(2) of the Speedy Edge.
u Release the tabs (10).
Note: The paint applicator can not be tted with the paint
reservoir syringe in place.
Removing the paint applicator (g. B)
u Press in the paint applicator release tabs (10).
u Slide the paint applicator out of the main body (2) of the
Speedy Edge.
u Release the tabs (10).
Note: The paint applicator can not be removed with the paint
reservoir syringe in place.
Fitting the paint reservoir syringe (g. C - E)
Note: The paint reservoir syringe can not be attached until the
paint applicator has been tted
u Pull the plunger drive (4) to the back of the main body of
the Speedy Edge and clip it in place.
u Slide the paint reservoir syringe (3) into the main body of
the Speedy Edge.
u Pull the plunger drive (4) back and up to release it then
gently guide the plunger drive tip (11) into the recess (12)
in the back of the plunger (13) .
Removing the paint reservoir syringe (g. C - E)
u Pull the plunger drive (4) to the back of the main body of
the Speedy Edge and clip it in place.
u Slide the paint reservoir syringe (3) out of the main body
of the Speedy Edge.
Use
Filling with paint
Note: Wear disposable gloves to keep your hands clean.
u Slide the paint reservoir syringe (3) into the ll sleeve (8).
u Lower the tip of the ll sleeve (8) into the paint.
u Fill the paint reservoir syringe (3) by slowly pulling back
the plunger (13).
Lataa käyttöohje suomalainen (PDF, 1.64 MB)
(Mieti ympäristöä ja tulosta tämä käyttöopas vain, jos se on todella tarpeen)

Loading…

Arviointi

Kerro meille mielipiteesi Black and Decker BDPE400 Saumauspistooli arvioimalla tuote. Haluatko jakaa tuotekokemuksesi tai kysyä kysymyksen? Jätä kommentti sivun alalaidassa.
Oletko tyytyväinen kohteeseen Black and Decker BDPE400 Saumauspistooli?
Kyllä Ei
Arvostele tuote ensimmäisenä
0 äänet

Keskustele tuotteesta

Täällä voit jakaa mielipiteesi Black and Decker BDPE400 Saumauspistooli:sta. Jos sinulla on kysyttävää, lue ensin huolellisesti käyttöohje. Käsikirjaa voi pyytää yhteydenottolomakkeellamme.

tonny 08-06-2021
voitko silti ostaa tämän tiivistysaseen, jos voi, mistä voin tilata sen?

vastaa | Tästä oli apual (0) (Googlen kääntämä)
tonny 08-06-2021
voitko vielä ostaa tämän tiivisteen

vastaa | Tästä oli apual (0) (Googlen kääntämä)

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Black and Decker BDPE400 Saumauspistooli. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Black and Decker. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Black and Decker BDPE400 Saumauspistooli käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Tuotemerkki Black and Decker
Malli BDPE400
Kategoria Saumauspistoolit
Tiedostotyyppi PDF
Tiedoston koko 1.64 MB

Kaikki käsikirjat kohteelle Black and Decker Saumauspistoolit
Lisää Saumauspistoolit käsikirjoja

Usein kysytyt kysymykset kohteesta Black and Decker BDPE400 Saumauspistooli

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Voinko säilyttää sähkötyökaluja vajassa tai autotallissa? Todennettu

Yleensä sähkötyökaluja voi säilyttää vajassa tai autotallissa, vaikka se joskus jäätyy siellä. Sähkötyökalun käyttöiän kannalta on kuitenkin parempi säilyttää se kuivassa paikassa ilman suuria lämpötilanvaihteluita. Aitassa tai autotallissa lämpötilaerot voivat aiheuttaa kondenssiveden muodostumista, joka voi aiheuttaa ruostetta. Lisäksi paristoilla toimivat työkalut kestävät lyhyemmin eivätkä lataudu yhtä hyvin hyvin alhaisissa lämpötiloissa. Lue käyttöopas aina huolellisesti, jotta voit olla varma siitä, miten sähkötyökalusi tulee säilyttää.

Tästä oli apual (33) Lue lisää
Käyttöohje Black and Decker BDPE400 Saumauspistooli

Liittyvät tuotteet

Aiheeseen liittyvät luokat

×
Download