Käyttöohje Bauknecht GTE 2805 A3+ Pakastin

Käyttöohje

q et

y

i

w

r

u

1

345

2

6

89

CLASE/KLASSE

CLASSE/CLASS

°C °F

SN 10 - 32 50 - 90

N 16 - 32 61 - 90

ST 16 - 38 61 - 100

T 16 - 43 61 - 110

7

5019 613 01315/A

INSTRUCTIONS FOR USE

GB

DIAGRAM OF THE APPLIANCE (Fig. 1)

A. Handle.

B. Safety lock (if provided).

C. Gasket.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor cooling grille.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

1. Digital temperature display: indicates the

temperature inside the freezer (fixed display) or the

set temperature (blinking display).

2. Decrease temperature button: this button lowers

the temperature.

3. Increase temperature button: this button raises the

temperature.

4. "Extra load" button: activates/deactivates the large

load function.

5. "Extra load" LED (yellow): indicates, when lit, that

the large load function has been selected.

6. "Green Intelligence" LED (blue): indicates, when lit,

that the “Green Intelligence” function is active (see

paragraph “Green Intelligence function”).

7. Alarm reset button: stops the acoustic alarm and

the power failure alarm LED (see paragraph "Alarms").

8. Alarm LED (red): blinks when an alarm condition

occurs (see paragraph "Alarms").

BEFORE USING THE APPLIANCE

Your new appliance is designed to be used in the

household and similar applications such as:

- kitchen areas in shops, offices and other working

environments

- farm houses

- by clients in hotels, motels, residences, bed &

breakfasts.

The product must only be used to store frozen food, to

freeze fresh food and to make ice.

Regulations require the appliance to be earthed.

The manufacturer declines all liability for injury to

persons or animals and for damage to property

resulting from failure to observe the above

procedures and reminders.

1. After unpacking, make sure that the appliance is

undamaged and that the door closes perfectly, with the

gasket remaining intact. Any damage must be reported

to your retailer within 24 hours after delivery of the

appliance.

2. Wait at least two hours before switching the appliance

on in order to ensure the refrigerant circuit is fully

efficient.

3. Installation and electrical connection must be carried

out by a qualified technician, according to the

manufacturer's instructions and local safety regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains supply,

ensure that the voltage corresponds to that given on

the rating plate located on the rear of the appliance.

• Electrical connections must be made in

accordance with local regulations.

INSTALLATION

• Unpack the appliance.

• Remove the 4 spacers inserted between the door

and the appliance. (Fig 3)

• Make sure the defrost water drain plug (if provided) is

correctly positioned (E).

• For optimum appliance operation and to avoid damage

when the door is opened, leave a space of at least 7 cm

from the rear wall and 7 cm at the sides. (Fig 4)

• Fit the accessories (if provided).

SWITCHING ON THE APPLIANCE

• Plug in the appliance.

• When the appliance is warm (internal temperature

above 0°C), two dashes appear on the digital display

(1).

• The red alarm LED (8) blinks and the acoustic alarm

sounds.

• The "Green Intelligence" LED (6) is on.

• Press the reset button (7) to deactivate the acoustic

alarm.

• The acoustic alarm stops while the red alarm LED

continues to blink.

• When the appliance reaches a temperature of at least -

12°C the red LED (8) stops blinking.

• Food can now be placed inside the freezer.

• The "Green Intelligence" LED (6) will remain lit until

the temperature set on the display is reached.

NOTE: Thanks to the efficient lid seal, the appliance lid

will not re-open easily immediately after closing. It is

necessary to wait a few minutes.

TEMPERA

TURE ADJUSTMENT

The appliance is normally factory-set for operation at the

recommended temperature of -18°C. The internal

temperature setting can be adjusted between -17°C and -

24°C or set to ECONOMY mode (see paragraph “ECO

function”). Proceed as follows:

• Press one of the two temperature adjustment buttons

(2; 3) once.

• The digital display (I) will blink, showing the previous

temperature setting.

• Press the button (3) several times as required for a

warmer temperature setting. The value changes by 1°C

with each press of the button. During this process, the

value shown on the digital display blinks.

• Press button (2) several times as required to lower the

temperature. The value changes by 1°C with each press

of the button. During this process, the value shown on

the digital display blinks.

• About 5 seconds after the button has been pressed for

the last time, the set temperature is stored, the digital

display (1) stops blinking and shows the internal

temperature again.

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi Bauknecht GTE 2805 A3+ Pakastin. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen Bauknecht. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen Bauknecht GTE 2805 A3+ Pakastin käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle Bauknecht Pakastimet
Lisää Pakastimet käsikirjoja

Usein kysytyt kysymykset kohteesta Bauknecht GTE 2805 A3+ Pakastin

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.