Käyttöohje AEG-Electrolux AEC7572 Clario Pölynimuri

Käyttöohje

2

3

Accessories

1 Dustbag, s-bag

TM

,

s-bag

TM

Clinic

2* Telescopic tube

3* Extension tube (2)

4 Hose handle

5 Carpet/hard floor

nozzle

6* Parquet nozzle

7* Power nozzle

8* Turbo nozzle

9 Crevice nozzle

10 Upholstery nozzle

Safety precautions

Clario should only be used by adults and only for normal vacuum-

ing in a domestic environment. The vacuum cleaner features

double insulation and does not need to be earthed.

Never vacuum:

• In wet areas.

• Close to flammable gases, etc.

• Without an s-bag

TM

(this may damage the

cleaner).

A safety device is fitted which prevents the cover

closing without an s-bag

TM

. Do not attempt to

force cover shut.

Never vacuum:

• Sharp objects.

• Fluids (this can cause serious damage to the

machine).

• Hot or cold cinders, lit cigarette butts, etc.

• Fine dust from plaster, concrete, flour or ash,

for example. The above can cause serious damage

to the motor – damage which is not covered by

the warranty.

Electrical cable precautions:

• A damaged cable must be replaced by an authorised AEG-

Electrolux service centre. Damage to the cleaner cable will

not be covered by the warranty.

• Never pull or lift the vacuum cleaner by the cable.

• Disconnect the plug from the mains before

cleaning or maintenance of the vacuum cleaner.

• Regularly check that the cable is not damaged.

Never use the vacuum cleaner if the cable is

damaged.

All service and repairs must be carried out by an authorised

AEG-Electrolux service centre.

Always keep the vacuum cleaner in a dry place.

Before starting

11 Check that the s-bag

TM

dustbag and motor filter are in

place.

12 Insert the hose until the catch clicks to engage (press the

catch to release the hose).

13 Attach the extension wand or telescopic wand (only on

certain models) to the hose handle and floor nozzle (to take

them apart again, twist and pull).

14 Extend the cord and plug it into the wall socket.

The vacuum cleaner has an integrated cord winder.

15 Press the foot pedal to rewind the cable (take hold of the

plug to prevent it striking you).

16 Press the On/Off button with the foot to start the vacuum

cleaner.

* Certain models only

17* Adjust suction power using the suction control on the

vacuum cleaner or the suction control on the hose handle.

18 A practical parking feature (as well as minimizing the risk of

backache) makes things easier when pausing during clean-

ing.

19 The parking feature makes it easier to move and store the

vacuum cleaner.

Use the nozzles as follows:

Carpets: Use the carpet/hard floor nozzle with the

lever in position (20). Reduce suction power for small carpets.

Hard floors: Use the carpet/hard floor nozzle wit

the lever in position (21).

Wooden floors: Use the parquet nozzle (certain models only, 6).

Upholstered furniture: Use the upholstery nozzle (10).

Crevices, corners, etc.: Use the crevice nozzle (9).

Using the power socket (requires a Clario equipped with a

designated power socket. The power nozzle is available as an

accessory.)

22 Attach the nozzle to the tube (certain models only).

23 Connect the power nozzle to the socket on the vacuum

cleaner.

24 Use the clips to secure the cable along the tubes and hose.

25 The power nozzle starts operating when the vacuum

cleaner is switched on.

Using the turbo nozzle (certain models only)

26 Attach the nozzle to the tube.

27 Adjust the suction power by opening or closing the air vent.

Note: Do not use the power or turbo nozzle on fur rugs, rugs with

long fringes or a pile depth exceeding 15 mm. To avoid damaging

the carpet, do not keep the nozzle stationary whilst the brush

is rotating. Do not pass the nozzle across electric cables, and be

sure to switch off the vacuum cleaner immediately after use.

Replacing the s-bag

TM

/clening the filter

28 The dust bag, s-bag

TM

must be replaced when the indicator

window is completely red. Read the indicator with the floor

nozzle lifted up from the carpet.

29 Remove the hose and open the lid.

30 Pull the cardboard holder to remove the s-bag

TM

. This auto-

matically closes the dust bag and stops dust from leaking

out.

31 Insert a new s-bag

TM

by pushing the cardboard holder

straight down in its tracks. Close the lid.

Note: Replace the s-bag

TM

even if it is not full (it may be blocked).

Also replace after using carpet-cleaning powder. Use only AEG-

Electrolux original dust bags –

s-bag

TM

Classic, s-bag

TM

Clinic or s-bag

TM

Anti-odour.

English

Replacing the motor filter (Ref. No. EF54)

Should be done with every 5th replacement of the dust bag,

s-bag

TM

32 Depress the catch and open the lid.

33 Remove the old filter

34 Insert a new filter and close the lid.

Taking care of the filters

The more often the better for the efficiency of the cleaner.

There are four types of exhaust filter, depending on the vacuum

cleaner model:

• Hepa H12 washable (Ref. No. EFH12W)

• Hepa H12 non washable (Ref. No. EFH12)

• Microfilter with frame (Ref. No. EF17)

• Microfilter (Ref. No. EF2)

Replacement of the microfilter and the non-washable

HEPA filter

The filters must always be replaced with new ones and cannot

be washed.

35 Open and remove the lid, remove the filter (every fifth bag

change).

36 Insert a new filter and replace the lid as shown in the picture.

Cleaning the washable HEPA filter

(ref. no. EFH12W, some models only)

Should be done with every 5th replacement of the dust bag,

s-bag

TM

37 Open and remove the lid, then remove the filter.

38 Rinse the inside (dirty side) of the filter in warm tap water.

Tap the filter frame to remove excess water. Repeat four

times and allow the filter to dry. Note: Do not use cleaning

agents and avoid touching the delicate filter surface.

39 Replace the filter and lid as shown.

Cleaning the hose and nozzle

The vacuum cleaner stops automatically if the nozzle, tube, hose

or filters and s-bag

TM

becomes blocked. In such cases, disconnect

from mains and allow to cool for 20-30 minutes. Clear blockage

and/or replace filters and s-bag

TM

and restart.

Cleaning tubes and hoses

40 Use a cleaning strip or similar to clear the tubes and hose.

41 It may also be possible to remove the obstruction in the

hose by squeezing it. However, be careful in case the

obstruction is caused by glass or needles caught inside the

hose.

Note: The warranty does not cover any damage to the hose

caused by cleaning it.

Cleaning the floor nozzle

42 To avoid deterioration of suction power, frequently clean the

carpet/hard floor nozzle. The easiest way to clean it is by

using the hose handle.

Cleaning the power nozzle (certain models only)

43 Disconnect from the mains, and remove entangled threads

etc. by snipping them away with scissors.

44 Use a screwdriver to remove the nozzle cover.

45 Remove the brush cylinder and bearings, then clean as

necessary.

46 To clean the wheels, gently lever them from their mountings

and clean as necessary.

47 Replace the cover and make sure it is securely fastened.

Cleaning the turbo nozzle (certain models only)

48 Remove the nozzle from the vacuum cleaner tube and

remove entangled threads etc. by snipping them away with

scissors. Use the hose handle to vacuum the nozzle.

Troubleshooting

The vacuum cleaner does not start

1 Check that the cable is connected to the mains.

2 Check that the plug and cable are not damaged.

3 Check for a blown fuse.

The vacuum cleaner stops

1 Check whether the dust bag, s-bag

TM

is full. If so, replace it

with a new one.

2 Is the nozzle, tube or hose blocked?

3 Are the filters blocked?

Water has entered the vacuum cleaner

It will be necessary to replace the motor at an authorised AEG-

Electrolux service centre. Damage to the motor caused by the

penetration of water is not covered by the warranty.

Consumer information

AEG-Electrolux decline all responsibility for all damages arising

from any improper use of the appliance or in cases of tampering

with the appliance.

This product is designed with the environment in mind. All

plastic parts are marked for recycling purposes. For details see

our web site:

www.electrolux.de

Arviointi

Lisää tästä ohjekirjasta

Ymmärrämme, että on mukavaa, että sinulla on paperikäyttöinen käyttöopas laitteellesi AEG-Electrolux AEC7572 Clario Pölynimuri. Voit aina ladata oppaan verkkosivuiltamme ja tulostaa sen itse. Jos haluat alkuperäisen käyttöoppaan, suosittelemme ottamaan yhteyttä osoitteeseen AEG-Electrolux. He saattavat pystyä toimittamaan alkuperäisen ohjekirjan. Etsitkö laitteen AEG-Electrolux AEC7572 Clario Pölynimuri käyttöopasta toisella kielellä? Valitse haluamasi kieli kotisivuiltamme ja etsi mallinumero nähdäksesi, onko sitä saatavilla.

Tekniset tiedot

Kaikki käsikirjat kohteelle AEG-Electrolux Pölynimurit
Lisää Pölynimurit käsikirjoja

Usein kysytyt kysymykset kohteesta AEG-Electrolux AEC7572 Clario Pölynimuri

Tukitiimimme etsii hyödyllisiä tuotetietoja ja vastaa yleisiin kysymyksiin. Jos huomaat yleisissä kysymyksissä virheen, kerro siitä meille yhteydenottolomakkeella.

Liittyvät tuotteet

Käyttöohje

Miele S 8730 Pölynimuri

Käyttöohje

Gorenje VC1811SFSWR Pölynimuri

Käyttöohje

Bissell 3400N CrossWave X7 Plus Pölynimuri

Käyttöohje

Gorenje RVC216BK Pölynimuri

Käyttöohje

Miele S 648 Pölynimuri

Käyttöohje

Miele S 6230 Pölynimuri

Käyttöohje

Miele S 4560 Pölynimuri

Käyttöohje

Miele S 8530 Pölynimuri

Aiheeseen liittyvät luokat